Shopping Cart
Your cart is empty.
Browse Categories
Browse by Manufacturer

Liquiguard SolidStepCote 01

Price: From $29.95 to $899.75
Manufacturer: Liquiguard
Manufacturer Part No: SSC1101

Product Options


SolidStepCote 01 prevents slip and fall accidents in areas that are less likely to become extremely wet or slippery.

It offers a relatively smooth texture, and provides slip resistance with the use of very small aggregate particles and nanotechnology materials; similar in texture to 400-grit sandpaper.

SolidStepCote 01 is designed for indoor surfaces that need anti slip protection, but must maintain a close appearance to the original surface.

It is a favorable solution for polished stone surfaces such as marble and granite found in homes and lobbies; as well as wood- or vinyl-laminate flooring in homes and office environments.

This eco-friendly product contains extremely low VOC’s, and has no fumes or odors. It can be applied easily with a paint brush, paint roller or low pressure airless spray.

Key Benefits:

Green: Non-Toxic, Minimal VOC's, Fumes, Odors
Multi-Surface Solution
Ease of Application 
Single Component Product (No Mixing Req’d)
Highly Water Resistant
Does Not Mold or Mildew
Protects Grout Lines
Quick Drying Times
Enhanced for UV Protection (Does not yellow, crack or peel)
Does Not Harm Underlying Floor Surface
Does Not Attract Dirt
Stain Resistant
Easy To Clean

Application Instructions:
SolidStepCote may be applied by brush, roller (short nap) or low pressure airless spray. A gallon of SolidStepCote can provide protection over approximately 350 square feet depending on the nature of the surface. Stir or shake the SolidStepCote container vigorously to mix well prior to use. The targeted surface should be free of dirt, debris and oil or grease, prior to application. The coating goes on easily and dries to a clear glossy finish. One coat is usually sufficient. However if a second is desired, allow the first coat to dry thoroughly for an hour or more depending on ambient temperature. Allow 24 hours or more for full cure before subjecting the surface to heavy traffic. Do not apply at temperatures below 50°F or above 90°F. Avoid heavy buildup, puddling and overlapping.

Application Instruction PDF

Appropriately mask off areas that need to be kept free of SolidStepCote. Wipe off overruns, spills and splatters immediately with water.  Thoroughly clean hands and tools after use with soap and warm water. Observe all personal precautions as you would with any other paint or coating product.

Product Reviews

(0 Ratings, 0 Reviews)