Shopping Cart
Your cart is empty.
Browse Categories
Browse by Manufacturer

Liquiguard SolidStepCote 02

Price: From $29.95 to $899.75
Manufacturer: Liquiguard
Manufacturer Part No: SSC2101

Product Options


SolidStepCote 02 is our recommended solution for homes and businesses that must prevent slip and fall accidents while still maintaining floor aesthetics.

It features a fine aggregate—similar to 200-grit sandpaper—which is almost invisible to the eye, but still addresses floor safety.

SolidStepCote 02 creates an easy-to-clean surface for traditional floor cleaning modalities, including mopping. And it is a perfect fit for any indoor flooring surface such as VCT, concrete, ceramic tile and more.

Common environments for SolidStepCote 02 include, but are not limited to: hospitals, restaurants (dining areas), grocery stores, retail stores, bathroom floors, foyers and hallways.

This eco-friendly product contains extremely low VOC’s, and has no fumes or odors. It can be applied easily with a paint brush, paint roller or low pressure airless spray.

Key Benefits:
Green: Non-Toxic, Minimal VOC's, Fumes, Odors
Multi-Surface Solution
Ease of Application 
Single Component Product (No Mixing Req’d)
Highly Water Resistant
Does Not Mold or Mildew
Protects Grout Lines
Quick Drying Times
Enhanced for UV Protection (Does not yellow, crack or peel)
Does Not Harm Underlying Floor Surface
Does Not Attract Dirt
Stain Resistant
Easy To Clean

SolidStepCote may be applied by brush, roller (short nap) or low pressure airless spray. A gallon of SolidStepCote can provide protection over approximately 350 square feet depending on the nature of the surface. Stir or shake the SolidStepCote container vigorously to mix well prior to use. The targeted surface should be free of dirt, debris and oil or grease, prior to application. The coating goes on easily and dries to a clear glossy finish. One coat is usually sufficient. However if a second is desired, allow the first coat to dry thoroughly for an hour or more depending on ambient temperature. Allow 24 hours or more for full cure before subjecting the surface to heavy traffic. Do not apply at temperatures below 50°F or above 90°F. Avoid heavy buildup, puddling and overlapping.

Application Instructions PDF

Care and Maintenance: 
SolidStepCote, due to its textured nature, will attract and hold dirt and oils and must be cleaned regularly to dislodge or break down the buildup of contaminants that will, over time, create discoloration in the surface. 

SolidStepCote may be cleaned daily with mops or nylon bristle brushes and standard liquid floor cleaners.  Clean your SolidStepCote treated floor, tub or other surface periodically as needed with a soft to medium nylon bristled brush or push broom using a non-solvent based cleaner/degreaser. 


DO NOT clean SolidStepCote treated surfaces with highly abrasive tools such as Scouring Pads, Motorized Rotary Cleaning Devices, Abrasive Sponges, Burnishing Devices, Steel Brushes, Diamond Pads, Sandpapers or other Buffing Devices.  Over abrasion will damage the surface of the coating, removing the non-slip textured aggregate and damaging the surface appearance.   DO NOT use Harsh Chemical Solvents to clean as they may damage or remove the coating. 

Appropriately mask off areas that need to be kept free of SolidStepCote. Wipe off overruns, spills and splatters immediately with water.  Thoroughly clean hands and tools after use with soap and warm water. Observe all personal precautions as you would with any other paint or coating product.

Product Reviews

(0 Ratings, 0 Reviews)