Shopping Cart
Your cart is empty.
Browse Categories
Browse by Manufacturer

Liquiguard SolidStepCote 03


Price: From $29.95 to $899.75
Manufacturer: Liquiguard
Manufacturer Part No: SSC3102

Product Options

Size:

SolidStepCote 03 is our most popular formula to prevent slip and fall accidents indoors and outdoors.

The surface is coarser than SolidStepCote 02, with texture similar to 100-grit sandpaper. It provides greater slip resistance for homes and businesses that are more likely to encounter wet or slippery surfaces.

It is designed for intense indoor protection and lighter outdoor protection.

SolidStepCote 03 may be applied on any surface where flooring aesthetics aren’t a concern. Due to the solution’s enhanced slip resistance, the original surface aesthetic becomes less visible compared to SolidStepCote 02.

This eco-friendly product contains extremely low VOC’s, and has no fumes or odors. It can be applied easily with a paint brush, paint roller or low pressure airless spray.

It’s the preferred solution for bathtubs and showers.

Key Benefits:
Green: Non-Toxic, Minimal VOC's, Fumes, Odors
Multi-Surface Solution
Ease of Application 
Single Component Product (No Mixing Req’d)
Highly Water Resistant
Does Not Mold or Mildew
Protects Grout Lines
Quick Drying Times
Enhanced for UV Protection (Does not yellow, crack or peel)
Does Not Harm Underlying Floor Surface
Does Not Attract Dirt
Stain Resistant
Easy To Clean

Application:
SolidStepCote may be applied by brush, roller (short nap) or low pressure airless spray. A gallon of SolidStepCote can provide protection over approximately 350 square feet depending on the nature of the surface. Stir or shake the SolidStepCote container vigorously to mix well prior to use. The targeted surface should be free of dirt, debris and oil or grease, prior to application. The coating goes on easily and dries to a clear glossy finish. One coat is usually sufficient. However if a second is desired, allow the first coat to dry thoroughly for an hour or more depending on ambient temperature. Allow 24 hours or more for full cure before subjecting the surface to heavy traffic. Do not apply at temperatures below 50°F or above 90°F. Avoid heavy buildup, puddling and overlapping.

Application Process PDF

Cleanup:
Appropriately mask off areas that need to be kept free of SolidStepCote. Wipe off overruns, spills and splatters immediately with water.  Thoroughly clean hands and tools after use with soap and warm water. Observe all personal precautions as you would with any other paint or coating product.

Product Reviews

(0 Ratings, 0 Reviews)